aplon
hand sugar
Zoulla
Order from
Hair-removers.com
Hair-removers.com
sites that carry most items
Aplon all natural hair remover
DIRECTIONS FOR USE: The Aplon ball works best at room temperature between 70°F to 85°F (22°C to 30°C). Your hands and the skin areas to be treated must be clean and dry. Hair to be removed must be long enough for Aplon to adhere. Since Aplon is water soluble, YOU MUST NEVER ALLOW WATER OR ANY KIND OF MOISTURE TO COME IN CONTACT WITH Aplon , EITHER IN THE TUBE OR ON THE SKIN.
1.
Aplon
works with your body heat. Tighten cap and put tube upside down in hot water,
110°-130°F (43°-55°C) for about 1-2 minutes or until
Aplon
can be squeezed from tube.
(DO NOT USE MICROWAVE OVEN -overheating
Aplon
will ruin its effectiveness and cause it to lose it's natural moisture.)
Make sure it is not too hot by touching tube to face or trying small amount on
fingers. Roll tube between palms to distribute heat evenly.
2. Squeeze a small amount of Aplon on first two finger tips for forming small balls or directly on leg for larger amounts.
3. With thumb, roll Aplon on finger tips into ball. If it is too warm, it will be sticky and not form into a ball, wait a few seconds for it to cool before proceeding. For facial hair a grape size ball is sufficient, for legs, arms and underarms use about a small egg size ball.
4. Press the Aplon ball on the center of the area to be treated. Start at the center and work to the outer edges using the side or tip of fingers, or on larger area, both thumbs.
5. Push slowly to spread evenly over area to be treated. Never tap or pat!
6. When you have covered the area with Apron, wait a few seconds then flip up
an outer edge with your finger tip.
7. Grasp enough of the edge to quickly zip if off the skin. Pull to work against direction of hair growth.
Aplon is reusable.
8. Knead the same piece of
Aplon
and roll into a ball again. The same ball can be used many times on the same
area, if necessary, until all the hair has been removed or apply on a new area
to be treated. As the
Aplon
ball is used it will fill with hair and dead skin until it no longer spreads
well. Discard used ball and squeeze out enough to start a new ball. Never save
used
Aplon
from one day to another and never use
Aplon
that someone else has used.
SUGGESTED USES:
Sculpturing Eyebrows -A small ball should be carefully placed on brow area to be treated. Smooth out carefully. For brows that have been plucked or shaved for many years, allow hair to grow at least 1/8" (3mm) long. Remove Apron with one fast pull against the direction of hair growth. If Aplon gets placed incorrectly simply remove by rinsing with warm tap water.
Sideburns -Use grape size Aplon ball and hold away hair to be retained with tape. Spread evenly with fingertips then zip up to remove.
Upper Lip -Use grape size Aplon ball starting at center of lip and working outward. Remove starting at outer corners of mouth.
Chin -Again use grape size Aplon ball. Place it on center of chin and spread it outward. Remove with one fast pull.
Legs and Arms -Squeeze small amount of Aplon on leg to be sure it is not too hot. When comfortable and spreadable use a sufficient amount to cover a workable area, small egg size ball, or use It directly from the tube spreading to an even cover. Remove by pulling off rapidly against the direction of hair growth.
Underarms
-Use an egg size
Aplon
ball. Underarms must be very dry and hair at least 1/8" (3mm) long for
Aplon
to adhere. Remove
Knees and Elbows -Again, using small egg size Aplon ball, spread on bent joint so skin is taunt, pull off against direction of hair growth.
Sculpturing Bikini Lines -Use a sufficient amount to comfortably cover area on abdomen/thighs. Remove Aplon by pulling against hair growth.
When you are finished, wash all treated areas with warm water and dry thoroughly. Aplon also removes dead skin so you will notice a softer feeling and appearing skin. Any redness or slight irritation appearing immediately following hair removal is temporary because Aplon does not simply break off the hair, rather it is removed from the follicle. This makes regrowth much slower and the hair much finer. Repeat the process in 4-6-8-10 weeks or as needed depending on hair regrowth.
SPECIAL TIPS:
If fingers become sticky, wash in cool water and dry well. Aplon is affected by room and body temperatures. If too cool, Aplon will be stiff and difficult to remove from the tube or spread on the skin. See DIRECTIONS FOR USE, #1. If room temperature is below 70°F (23°C) you may have to go into a warmer room or leave Aplon on longer for body temperature to aid the process.
When too warm, Aplon will be too soft and sticky. If overheated, wait a few seconds until it cools to a workable temperature.
When weather is over 85°F (30°C), you will have to use it in a cooler atmosphere. Remember , the skin you wish to treat must be clean and dry! Aplon will not work properly on hair which is too short! The first time you use an Aplon ball you must prepare by allowing hair to regrow to at least 1/8" (3mm). The results, using Aplon , are very much worth the initial wait! When the hair finally does reappear it is thinner and softer than shaved hair and so not as noticeable.
PRECAUTION:
If you have a history of skin hypersensitivity, a small area of hair should be removed with Aplon (preferably on the inner thigh). Wait 24 hours for allergic reaction of redness, swelling, or itching. With any visible signs of reaction, DO NOT CONTINUE TO USE PRODUCT! DO NOT use Aplon on sunburned or broken skin. DO NOT apply Aplon on warts, moles or varicose veins.
If Aplon is accidentally applied to an undesirable area, rinse it off under warm tap water using a gently stroking motion.
QUESTIONS:
1. Aplon will not come out of the tube.
ANSWER; With cap securely on, put the tube upside down in hot tap water 110°-130°F (43°-55°C) for 1-2 minutes or until Aplon can be squeezed from tube.
2. Aplon is hard after being squeezed out of the tube. ANSWER: Move to a warmer place (See Special Tips). If still too hard moisten hand, and knead piece of Aplon until workable.
3. Too sticky, can't be removed from skin.
ANSWER: If Aplon still can't be removed -wash off with warm tap water using gentle stroking motion. Start again with new Aplon ball.
4. Can the color of Aplon vary?
ANSWER: Yes, depending on the supplier of some of the natural ingredients, the color can vary from amber to brown.
5. Can Aplon be painful?
ANSWER: Removing hair from the follicles may be slightly painful to some first time users. The faster you pull Aplon off the better.
Zoulla, Inc.
Order from
Hair-removers.com
Hair-removers.com
on a new Product or if we need to correct something click here